Tag Archive for: assembly

Posts

[Video] - E27 - finishing the counterweight (part3)

October 11, 2018

In this Episode I finally finish the counterweight, after installing…

[Video] - E26 - changing the frame and installing the counterweight (part2)

October 4, 2018

In this Episode, I change the frame of libreflip a bit and then…

[Video] E19 - I failed! Lets do the camera holders - again.

August 9, 2018

In this Episode I explain the shortcomings (Fails) of the old…

[Video] E14 - Lets mount these rubber springs!

July 5, 2018

In this Episode I mount the rubber springs that act like a counter…

[Video] E11 - assembling all the Modules of Libreflip

June 14, 2018

Finally all the Modules come together and we can see the machine…

[Video] E09 What about the User Interface? Mounting the Touchscreen!

May 31, 2018

Libreflip needs a user interface - and with todays technology,…

[Video] E08 assembling the structure of Libreflip

May 24, 2018

After preparing a lot of pieces in the other Episodes, in this…

Latest news

[Video] E33 – Searching reflections! Do I need to rebuild the suction box?October 31, 2019 - 19:58
In this Video, I verify and check that the geometry of the suctionbox is correct by checking if there are visible reflections of the light on a scanned page. Unfortunately a reflection exist, but luckily it is not too much in the way and probably can be moved a bit further. This means that I […]
[Video] E32 – The new Stepper Driver works and I am taking apart the old scanner.October 19, 2019 - 19:14
In this Episode we get the new stepper driver to work and then we decide that Libreflip has to leave the workshop, to be more accessible for the team to continue the software- and firmware development. Because of this, I need to take apart the old book scanner. The old book scanner will continue its […]
[Video] E31 – Exchanging the Stepper Driver and discussing “COTS” vs “Custom PCB”October 7, 2019 - 19:09
In this Episode we exchange the stepper driver from Episode 30 and replace it with a new, much more intelligent stepper driver. Also we discuss, explain and ask for your Input and Opinion on the question of “Consumer-off-the-shelf” vs “Custom PCB”. Support Libreflip! Libreflip has no marketing budget and will never have one. The book scanner […]
[Video] E30 – Will it suck? Will it flip? – We reached a HUGE Milestone!September 17, 2019 - 14:20
In this Episode we chase out some more bugs. We found out that the suction box has still some holes and was leaking. We also found out that the blower fan worked and had the right timing, but was switched off. We also found a solution that works without gravity, tested the counterweight and the […]